The cooler expansion valve (cooler magnet valve) is controlled by the air conditioning amplifier assembly (for cool box).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the No. 1 cooler wiring harness sub-assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 - Body ground | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to No. 1 Cooler Wiring Harness Sub-assembly) |
OK
NG
Disconnect the No. 1 cooler wiring harness sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 6 - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to No. 1 Cooler Wiring Harness Sub-assembly) |
OK
NG
Replace the No. 1 cooler wiring harness sub-assembly with a normal one and check that the condition returns to normal.
Same problem does not occur.
OK
NG
Replace the cooler magnet valve assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>DISASSEMBLY).
Since the cooler magnet valve cannot be inspected while it is removed from the vehicle, replace the cooler magnet valve with a normal one and check that the condition returns to normal.
Same problem does not occur.
OK
NG