The No. 2 air conditioning control assembly communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the No. 2 air conditioning control assembly is operated.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B14B3 | Lost communication with the No. 2 air conditioning control assembly. | ·
No. 2 air conditioning control assembly ·
Air conditioning amplifier assembly ·
LIN communication system ·
Harness or connector |
Inspect the fuses and relays for circuits related to this system before performing the following inspection procedure.
Disconnect the No. 2 air conditioning control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E55-1 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E55-6 (IG+) - Body ground | Ignition switch off | Below 1 V |
| E55-6 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of harness connector
(to No. 2 air conditioning control assembly) |
OK
NG
Disconnect the E55 No. 2 air conditioning control assembly connector.
Disconnect the E36 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E55-4 (RLIN) - E36-20 (RLIN) | Always | Below 1 Ω |
| E55-4 (RLIN) or E36-20 - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the No. 2 air conditioning control assembly with new or known good one (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING UNIT (w/ Heater)>DISASSEMBLY).
Since the No. 2 air conditioning control assembly cannot be inspected while it is removed from the vehicle, replace the No. 2 air conditioning control assembly with a new or a known good one and check that the condition returns to normal.
| Result | Proceed to |
|---|---|
| OK (When troubleshooting according to the DTC) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
When troubleshooting according to the DTC:
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC B14B3 is not output.
When troubleshooting according to Problem Symptoms Table:
Check that the No. 2 air conditioning control assembly operation returns to normal.
No. 2 air conditioning control assembly operation returns to normal.
A
B
C