The damper servo motor (REC/FRS) sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the damper servo motor (REC/FRS) to any position, which controls the intake air settings (fresh, fresh/recirculation and recirculation).
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1442/42 | The air inlet damper position does not change even if the air conditioning amplifier assembly operates the damper servo motor (REC/FRS). | ·
Damper servo motor (REC/FRS) ·
Air conditioning harness assembly ·
Air conditioning amplifier assembly |
Use the Data List to check if the damper servo motor (REC/FRS) is functioning properly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Air Inlet Damper Targ Pulse | Mode damper servo motor (REC/FRS) target pulse / Min.: 128, Max.: 383 | for LHD:
·
RECIRCULATION: 286 (pulse) ·
FRESH: 258 (pulse) for RHD:
·
RECIRCULATION: 258 (pulse) ·
FRESH: 286 (pulse) |
·
Displayed between 258 and 286 pulse ·
Mode damper servo motor (REC/ FRS) system malfunction |
| Air Inlet Damper Actual Pulse | Mode damper servo motor (REC/FRS) actual pulse / Min.: 128, Max.: 383 | for LHD:
·
RECIRCULATION: 286 (pulse) ·
FRESH: 258 (pulse) for RHD:
·
RECIRCULATION: 258 (pulse) ·
FRESH: 286 (pulse) |
·
Displayed between 258 and 286 pulse ·
Mode damper servo motor (REC/ FRS) system malfunction |
When the mode switch is turned, the actual pulse changes following the target pulse.
| Result | Proceed to |
|---|---|
| Target pulse changes but actual pulse does not change | A |
| Target pulse and actual pulse do not change | B |
| Actual pulse changes following the target pulse (When troubleshooting according to the DTC) | C |
| Actual pulse changes following the target pulse (When troubleshooting according to Problem Symptoms Table) | E |
A
B
C
D
Replace the damper servo motor (REC/FRS).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC B1442/42 is not output
OK
B
Replace the air conditioning harness assembly with new or known good one.
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC B1442/42 is not output
OK
NG
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).
DTC B1442/42 is not output
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG