The air conditioning harness assembly connects the air conditioning amplifier assembly and servo motors. The air conditioning amplifier assembly supplies power and sends operation instructions to each servo motor through the air conditioning harness assembly. Each servo motor sends damper position information to the air conditioning amplifier assembly.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1497 | An error or open in the communication line. | ·
Air conditioning harness assembly ·
No. 1 air conditioning radiator damper servo sub-assembly (air mix damper servo) ·
No. 1 blower damper servo sub-assembly ·
No. 1 air conditioning radiator damper servo sub-assembly (mode damper servo) ·
No. 1 air conditioning radiator damper servo sub-assembly (cooler bypass damper servo) ·
Air conditioning amplifier assembly |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check for the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1497 is not output | A |
| DTC B1497 is output | B |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
Disconnect the E81 air conditioning amplifier assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E81-21 (+B1) - Body ground | Always | 11 to 14 V |
OK
NG
Select the Active Test, use the intelligent tester to generate a control command, and then check that items operate (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DATA LIST / ACTIVE TEST).
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Air Mix Servo Targ Pulse(D) | No. 1 air conditioning radiator damper servo sub-assembly (air mix damper servo) | Min.: 0, Max.: 255 | - |
| Air Inlet Damper Targ Pulse | No. 1 blower damper servo sub-assembly | Min.: 0, Max.: 255 | - |
| Air Outlet Servo Pulse(D) | No. 1 air conditioning radiator damper servo sub-assembly (mode damper servo) | Min.: 0, Max.: 255 | - |
| Cool Air Bypass Pulse | No. 1 air conditioning radiator damper servo sub-assembly (cooler bypass damper servo) | Min.: 0, Max.: 255 | - |
Arm of the damper servo motor selected in the Active Test moves smoothly.
According to the test result, proceed to the next step.
| Result | Proceed to |
|---|---|
| One of the damper servo motors is malfunctioning | A |
| All of the damper servo motors are malfunctioning | B |
A
B
According to the test result, proceed to the next step.
| Result | Proceed to |
|---|---|
| Only the No. 1 air conditioning radiator damper servo sub-assembly (air mix damper servo) is malfunctioning | A |
| Only the No. 1 blower damper servo sub-assembly is malfunctioning | B |
| Only the No. 1 air conditioning radiator damper servo sub-assembly (mode damper servo) is malfunctioning | C |
| Only the No. 1 air conditioning radiator damper servo sub-assembly (cooler bypass damper servo) is malfunctioning | D |
A
B
C
D
Temporarily replace the No. 1 air conditioning radiator damper servo sub-assembly (air mix damper servo).
Since the No. 1 air conditioning radiator damper servo sub-assembly (air mix damper servo) cannot be inspected while it is removed from the vehicle, replace the No. 1 air conditioning radiator damper servo sub-assembly (air mix damper servo) with a new or normally functioning one and check that the condition returns to normal.
Check for the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1497 is not output | A |
| DTC B1497 is output | B |
A
B
Temporarily replace the No. 1 blower damper servo sub-assembly (See page Vehicle Interior>HEATING / AIR CONDITIONING>BLOWER UNIT>DISASSEMBLY).
Since the No. 1 blower damper servo sub-assembly cannot be inspected while it is removed from the vehicle, replace the No. 1 blower damper servo sub-assembly with a new or normally functioning one and check that the condition returns to normal.
Check for the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1497 is not output | A |
| DTC B1497 is output | B |
A
B
Temporarily replace the No. 1 air conditioning radiator damper servo sub-assembly (mode damper servo).
Since the No. 1 air conditioning radiator damper servo sub-assembly (mode damper servo) cannot be inspected while it is removed from the vehicle, replace the No. 1 air conditioning radiator damper servo sub-assembly (mode damper servo) with a new or normally functioning one and check that the condition returns to normal.
Check for the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1497 is not output | A |
| DTC B1497 is output | B |
A
B
Temporarily replace the No. 1 air conditioning radiator damper servo sub-assembly (cooler bypass damper servo).
Since the No. 1 air conditioning radiator damper servo sub-assembly (cooler bypass damper servo) cannot be inspected while it is removed from the vehicle, replace the No. 1 air conditioning radiator damper servo sub-assembly (cooler bypass damper servo) with a new or normally functioning one and check that the condition returns to normal.
Check for the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1497 is not output | A |
| DTC B1497 is output | B |
A
B
Temporarily replace the air conditioning harness assembly.
Since the air conditioning harness assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning harness assembly with a new or normally functioning one and check that the condition returns to normal.
Check for the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC B1497 is not output | A |
| DTC B1497 is output | B |
A
B