When the light control switch is turned to the TAIL or HEAD position, this circuit sends an illumination signal to the mobile wireless charger cradle assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Troubleshoot the wireless charging system after confirming that the lighting system is functioning properly. (See Page Vehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Disconnect the mobile wireless charger cradle assembly connector.
| *a | Front view of wire harness connector (to Mobile Wireless Charger Cradle Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E150-7 (TAIL) - Body ground | Headlight dimmer switch assembly set to TAIL or HEAD | 11 to 14 V |
| Headlight dimmer switch assembly off | Below 1 V |
OK
NG