Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)
RM2660E _59 Vehicle Exterior _052850 WINDOW / GLASS _0255725 POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows) C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)  B2313  Glass Position Initialization Incomplete  


DESCRIPTION

The power window regulator motor assembly is driven by operating the power window switch. The power window regulator motor assembly has motor, regulator and ECU functions.

When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.

HINT:

This DTC may be stored for all the windows.


NOTICE:
·

When the power window regulator motor is reinstalled or replaced, the power window control system must be initialized.

·

After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:

(a)

Close the power window by fully pulling up the power window switch and holding it in the auto up position.

(b)

Open the power window by fully pushing down the switch.




Front Power Window Regulator Motor LH
DTC Code DTC Detection Condition Trouble Area
B2313
·

The power window regulator motor is not initialized.

·

The power window regulator motor malfunctions.


Front power window regulator motor assembly LH

Front Power Window Regulator Motor RH
DTC Code DTC Detection Condition Trouble Area
B2313
·

The power window regulator motor is not initialized.

·

The power window regulator motor malfunctions.


Front power window regulator motor assembly RH

Rear Power Window Regulator Motor LH
DTC Code DTC Detection Condition Trouble Area
B2313
·

The power window regulator motor is not initialized.

·

The power window regulator motor malfunctions.


Rear power window regulator motor assembly LH

Rear Power Window Regulator Motor RH
DTC Code DTC Detection Condition Trouble Area
B2313
·

The power window regulator motor is not initialized.

·

The power window regulator motor malfunctions.


Rear power window regulator motor assembly RH

PROCEDURE

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)

NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC
a.

Check for DTCs (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)>DTC CHECK / CLEAR).

Result
Result Proceed to
B2313 is not output A
B2313 output from front power window regulator motor LH B
B2313 output from front power window regulator motor RH C
B2313 output from rear power window regulator motor LH D
B2313 output from rear power window regulator motor RH E



A

END

B

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

C

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

D

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

E

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH