Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
69278C
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL
74280
4.REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY
74611C
5.REMOVE ASSIST GRIP COVER
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174C
7.REMOVE REAR INNER DOOR GLASS WEATHERSTRIP
86160C
8.REMOVE REAR SPEAKER SET (w/ Rear Speaker)
67842E
9.REMOVE REAR DOOR SERVICE HOLE COVER
68152C
10.REMOVE REAR DOOR GLASS RUN
67408F
11.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY
68124C
12.REMOVE REAR DOOR QUARTER WINDOW GLASS
68104
13.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
69804
14.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
85720G
15.REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY
Using a T25 "TORX" driver, remove the 3 screws and motor.
Be careful when removing the screws as the motor may fall and become damaged.
| *A | for Models with Jam Protection Function on 4 Windows |
| *B | for Models with Jam Protection Function on Driver Door Window Only |