63203F
1.INSTALL SLIDING ROOF HOUSING SUB-ASSEMBLY
Temporarily install the housing with the 8 bolts (vehicle body side) and 8 nuts.
Tighten the 8 nuts.
Tighten the 8 bolts.
63201P
2.INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY
Using a T25 "TORX" driver, temporarily install the glass with the 4 screws.
Perform a level check.
Check the difference in the level between the roof panel and the upper surface of the weatherstrip labeled "a" when the sliding roof glass is fully closed.
| Area | Specified Condition |
|---|---|
| A - A | -1.5 to +1.5 mm (-0.0591 to +0.0591 in.) |
| B - B | |
| C - C | |
| D - D | -1.0 to +1.5 mm (-0.0394 to +0.0591 in.) |
"+" represents the condition that the glass is above the panel level. "-" represents the condition that the glass is below the panel level.
Perform a gap check.
Check the gap between the roof panel and roof glass.
The gap must be even all around.
Tighten the 4 screws.
3.CHECK FOR WATER LEAK
After adjusting the sliding roof glass sub-assembly, check for water leakage into the vehicle interior.
If there are any leaks, readjust the sliding roof glass sub-assembly.
63218G
4.INSTALL SLIDING ROOF SIDE GARNISH LH
Attach the 5 claws to install the sliding roof side garnish.
63217K
5.INSTALL SLIDING ROOF SIDE GARNISH RH
Use the same procedures described for the LH side.
88566V
6.INSTALL REAR NO. 5 ROOF AIR DUCT
Attach the 2 clips to install the duct.
88566U
7.INSTALL REAR NO. 4 ROOF AIR DUCT
Use the same procedures described for the No. 5 roof air duct.
62180A
8.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH
Install the curtain shield airbag (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CURTAIN SHIELD AIRBAG ASSEMBLY>INSTALLATION).
62170A
9.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY RH
Use the same procedures described for the LH side.
63310
10.INSTALL ROOF HEADLINING ASSEMBLY
Install the roof headlining (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>INSTALLATION).
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
12.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).