52119A
1.REMOVE FRONT BUMPER COVER
for Standard:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(for Standard)>REMOVAL)
w/ Winch:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(w/ Winch)>REMOVAL)
53883F
2.REMOVE FRONT FENDER MAIN SEAL LH (for LHD)
Using a clip remover, detach the 3 clips and remove the front fender main seal LH.
53882H
3.REMOVE FRONT FENDER MAIN SEAL RH (for RHD)
Using a clip remover, detach the 3 clips and remove the front fender main seal RH.
53228A
4.REMOVE LOWER NO. 1 RADIATOR MOUNTING BRACKET
Remove the bolt and lower No. 1 radiator mounting bracket.
53629
5.REMOVE HOOD LOCK CONTROL CABLE COVER
Remove the 3 screws.
Detach the claw and remove the hood lock control cable cover.
53510
6.REMOVE HOOD LOCK ASSEMBLY
Remove the 2 bolts and nut.
Remove the hood lock assembly.
Disconnect the connector.
Disconnect the hood lock control cable assembly.
53601
7.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Detach the 2 claws.
Disconnect the hood lock control cable assembly and remove the hood lock control lever sub-assembly.
53630
8.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
| *a | Clamp | - | - |
Using a screwdriver, disconnect the 6 clamps shown in the illustration.
Tape the screwdriver tip before use.
Pull the cable from the engine room and remove it.
53630
9.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
| *a | Clamp | - | - |
Using a screwdriver, disconnect the 6 clamps shown in the illustration.
Tape the screwdriver tip before use.
Pull the cable from the engine room and remove it.