Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM › from 2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255761 POWER BACK DOOR SYSTEM J

DOOR / HATCH  POWER BACK DOOR SYSTEM  Door Control Switch Circuit  


DESCRIPTION

The back door control switch only turns on while the switch is being pressed, and turns off when the back door control switch is released.

When the back door control switch is on, a power back door close request signal is input to the power back door unit assembly (power back door ECU) to close the back door.

WIRING DIAGRAM

B312260E16
5.073,1.708 5.646,1.854 0.573,0.146 10 false L52 5.063,1.885 7.083,2.229 2.021,0.344 10 false Power Back Door Unit Assembly 2.052,1.219 2.354,1.365 0.302,0.146 10 false S25 2.281,0.771 2.375,0.917 0.094,0.146 10 false 4 3.365,0.771 3.542,0.917 0.177,0.146 10 false 3 5.427,0.771 5.531,0.917 0.104,0.146 10 false 4 5.604,0.854 5.906,1 0.302,0.146 10 false DS1 2.052,1.375 3.656,1.719 1.604,0.344 10 false Back Door Control Switch

PROCEDURE

1.READ VALUE USING GTS (PBD CLOSE SW)
a.

Check the Data List for proper functioning of the back door control switch (See page Vehicle Exterior>DOOR / HATCH>POWER BACK DOOR SYSTEM>DATA LIST / ACTIVE TEST).

Back Door
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
PBD Close SW Back door control switch signal / ON or OFF ON: Back door control switch on
OFF: Back door control switch off
-

OK:

The display is as specified in the normal condition.




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT BACK DOOR CONTROL SWITCH
2.INSPECT BACK DOOR CONTROL SWITCH
a.

Remove the back door control switch (See page Vehicle Exterior>DOOR / HATCH>POWER BACK DOOR CONTROL SWITCH>REMOVAL).


b.

Inspect the back door control switch (See page Vehicle Exterior>DOOR / HATCH>POWER BACK DOOR CONTROL SWITCH>INSPECTION).



OK

3.CHECK HARNESS AND CONNECTOR (BACK DOOR CONTROL SWITCH - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] AND BODY GROUND)

NG

3.CHECK HARNESS AND CONNECTOR (BACK DOOR CONTROL SWITCH - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU] AND BODY GROUND)
a.

Disconnect the S25 back door control switch connector.


b.

Disconnect the L52 power back door unit assembly (power back door ECU) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
S25-3 - L52-4 (DS1) Always Below 1 Ω
S25-4 - Body ground Always Below 1 Ω
S25-3 - Body ground Always 10 kΩ or higher




OK

REPLACE POWER BACK DOOR UNIT ASSEMBLY (POWER BACK DOOR ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR