Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR DRIVE UNIT › from 2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255755 POWER BACK DOOR DRIVE UNIT A

DOOR / HATCH  POWER BACK DOOR DRIVE UNIT  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 64910J 3.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 4.REMOVE REAR NO. 2 SEAT ASSEMBLY RH (w/ Rear No. 2 Seat)

(See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>REMOVAL)

HINT:

Use the same procedure described for the LH side.


Hide 71845B 8.REMOVE REAR SEAT COVER CAP RH (w/ Rear No. 2 Seat)

Hide 62510P 9.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH

Hide 67939B 10.REMOVE CENTER BACK DOOR GARNISH

Hide 67937B 11.REMOVE BACK DOOR SIDE GARNISH RH

Hide 67847 12.REMOVE BACK DOOR SERVICE HOLE COVER RH

Hide 68910 14.REMOVE POWER BACK DOOR UNIT ASSEMBLY

a.
B192437

Disconnect the connector


b.

Remove the 4 bolts.


c.

Detach the 2 claws and remove the power back door unit assembly.