Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255761 POWER BACK DOOR SYSTEM J

DOOR / HATCH  POWER BACK DOOR SYSTEM  Back Door Lock Motor Circuit  


DESCRIPTION

The back door lock motor is built into the back door lock assembly. The power back door unit assembly (power back door ECU) controls the back door lock motor to open/close the back door. This power back door unit assembly (power back door ECU) applies current to terminals 2 and 1 to operate the motor to close the door. It reverses the direction of the current to operate the motor to open the door.

WIRING DIAGRAM

B312267E01
5.116,2.754 5.468,2.897 0.352,0.143 10 L52 5.116,2.895 7.153,3.237 2.037,0.342 10 Power Back Door Unit Assembly (Power Back Door ECU) 0.472,2.754 0.823,2.897 0.352,0.143 10 S22 2.306,2.147 2.415,2.289 0.109,0.143 10 2 2.306,0.536 2.415,0.679 0.109,0.143 10 1 5.556,2.147 5.652,2.289 0.096,0.143 10 1 5.556,0.536 5.652,0.679 0.096,0.143 10 2 5.756,2.245 6.108,2.388 0.352,0.143 10 DC- 5.756,0.635 6.108,0.777 0.352,0.143 10 DC+ 1.986,2.343 2.201,2.486 0.215,0.143 10 M- 1.986,0.733 2.201,0.875 0.215,0.143 10 M+ 0.472,2.895 2.123,3.237 1.651,0.342 10 Back Door Lock Assembly 1.113,1.382 2.115,1.724 1.003,0.342 10 Back Door Lock Motor

PROCEDURE

1.INSPECT BACK DOOR LOCK ASSEMBLY (CLOSER MOTOR OPERATION)
a.

Remove the back door lock assembly (See page Vehicle Interior>DOOR LOCK>BACK DOOR LOCK>REMOVAL).


b.

Inspect the back door lock assembly (See page Vehicle Interior>DOOR LOCK>BACK DOOR LOCK>INSPECTION).



OK

2.CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU])

NG

REPLACE BACK DOOR LOCK ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK ASSEMBLY - POWER BACK DOOR UNIT ASSEMBLY [POWER BACK DOOR ECU])
a.

Disconnect the S22 back door lock assembly connector.


b.

Disconnect the L52 power back door unit assembly (power back door ECU) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
S22-1 (M+) - L52-2 (DC+) Always Below 1 Ω
S22-2 (M-) - L52-1 (DC-) Always Below 1 Ω
S22-1 (M+) - Body ground Always 10 kΩ or higher
S22-2 (M-) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR