Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69278B
4.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
74232
5.REMOVE FRONT UPPER ARMREST BASE PANEL LH
74646
6.REMOVE DOOR ASSIST GRIP COVER LH
67602
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
68172A
8.REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH
87940
9.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
w/ Power Mirror Control System:
Disconnect the connector labeled A.
Detach the clamp.
Remove the 3 nuts and claw.
Remove the outer rear view mirror.