Use the same procedure for the LH and RH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
53292A
3.REMOVE UPPER RADIATOR SUPPORT SEAL
53883F
4.REMOVE FRONT FENDER MAIN SEAL LH
53882H
5.REMOVE FRONT FENDER MAIN SEAL RH
85221B
6.REMOVE FRONT WIPER ARM LH
85211B
7.REMOVE FRONT WIPER ARM RH
53383
8.REMOVE HOOD TO COWL TOP SEAL
55781E
9.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
85035
10.REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/o PTC Heater)
Detach the 3 claws and remove the washer nozzle.
Disconnect the hose.
85035
11.REMOVE WASHER NOZZLE SUB-ASSEMBLY (w/ PTC Heater)
Detach the connector clamp and disconnect the connector.
Detach the 4 claws and remove the washer nozzle.
Disconnect the hose.