Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › from 2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255805 HAZARD WARNING SWITCH A

LIGHTING (EXT)  HAZARD WARNING SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Navigation System)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55510F 3.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

Hide 55670 4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55680A 5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55412C 6.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Audio)

Hide 84330 7.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY (w/o Audio)

a.
E155869

Detach the 2 claws and remove the hazard warning signal switch assembly from the center No. 1 instrument cluster finish panel.


Hide 86120 8.REMOVE RADIO RECEIVER ASSEMBLY (for Radio and Display Type)

Hide 83910 9.REMOVE CLOCK ASSEMBLY (for Radio and Display Type (Hazard Warning Switch))

a.
E329568

Remove the 2 screws and clock assembly.


Hide 86110B 10.REMOVE MULTI-DISPLAY ASSEMBLY (w/ Navigation System (Hazard Warning Switch))

a.
E338421

Remove the 2 bolts and 2 screws.


b.
E338422

Pull the multi-display assembly to detach the 8 claws on the backside of the multi-display assembly and remove it.


c.

Disconnect each connector.