Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255806 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84345 1.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

a.
E334081

Attach the 2 claws to install a new stop light switch mounting adjuster.


Hide 2.INSTALL STOP LIGHT SWITCH

a.
E167768

Insert the stop light switch to the stop light switch mounting adjuster until it slightly touches the brake pedal.

NOTICE:

Do not depress the brake pedal.



b.
E334082E01
0.076,1.346 0.251,1.518 0.175,0.172 10 *a

Rotate the stop light switch clockwise by approximately one fourth of a rotation.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)


c.

Check the protrusion amount of the shaft.

Text in Illustration
*a Protrusion Amount Measurement Area

Standard:

1.5 to 2.6 mm (0.0591 to 0.1024 in.)



d.

Connect the connector.


Hide 55606 3.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY