Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER(w/ Winch) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255829 FRONT BUMPER(w/ Winch) A

EXTERIOR PANELS / TRIM  FRONT BUMPER(w/ Winch)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).

·

When installing the front bumper protector, heat the front bumper surface using a heat light.

Standard Heating Temperature:
Item Temperature
Front Bumper 20 to 30°C (68 to 86°F)




NOTICE:

Do not heat the front bumper excessively.


PROCEDURE

Hide 38649 1.INSTALL WINCH CONTROL WIRE

Hide 75111 2.INSTALL FRONT LICENSE PLATE BRACKET (w/ Bracket)

a.

Install the front license plate bracket with the 2 nuts.


Hide 52542A 3.INSTALL FRONT NO. 2 BUMPER PROTECTOR

a.

Clean the front bumper cover surface.

i.

Using a heat light, heat the front bumper cover surface.


ii.

Remove the double-sided tape from the front bumper cover.


iii.

Wipe off any tape adhesive residue with cleaner.



b.
B302219

Install new front No. 2 bumper protector.

i.

Remove the peeling paper from the face of new front No. 2 bumper protector.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Install the 2 front No. 2 bumper protectors as shown in the illustration.



Hide 53113C 4.INSTALL LOWER RADIATOR GRILLE LH

a.

Attach the 6 claws to install the lower radiator grille LH.


Hide 53112E 5.INSTALL LOWER RADIATOR GRILLE RH

HINT:

Use the same procedure described for the LH side.


Hide 52128B 6.INSTALL FRONT BUMPER HOLE COVER LH (w/ Fog Light)

a.

Attach the 5 claws to the front bumper hole cover LH.


b.

Install the 2 screws and 2 retainers.


Hide 52127D 7.INSTALL FRONT BUMPER HOLE COVER RH (w/ Fog Light)

HINT:

Use the same procedure described for the LH side.


Hide 52128B 8.INSTALL FRONT BUMPER HOLE COVER LH (w/o Fog Light)

a.

Attach the 5 claws to the front bumper hole cover LH.


b.

Install the screw and 2 retainers.


Hide 52127D 9.INSTALL FRONT BUMPER HOLE COVER RH (w/o Fog Light)

HINT:

Use the same procedure described for the LH side.


Hide 81220 10.INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)

Hide 81210 11.INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:

Use the same procedure described for the LH side.


Hide 52149 12.INSTALL FRONT BUMPER INNER BRACKET (w/ Fog Light)

a.

Attach the 3 claws and install the front bumper inner bracket.


Hide 82114 13.INSTALL NO. 4 ENGINE ROOM WIRE (w/ Fog Light)

a.

Attach the 11 clamps to install the No. 4 engine room wire.


b.

Connect the 2 connectors.