A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
58724B
1.INSTALL NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Install the No. 2 luggage compartment side cover protector with 2 new grommets.
Install the 2 screws.
58723B
2.INSTALL NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Use the same procedure described for the LH side.
57616B
3.INSTALL REAR BUMPER ARM BRACKET LH
Install the rear bumper arm bracket LH with the 2 bolts.
Connect the connector.
57615C
4.INSTALL REAR BUMPER ARM BRACKET
Install the rear bumper arm bracket with the bolt.
Use the same procedure to install the rear bumper arm bracket on the other side.
52172B
5.INSTALL REAR NO. 2 BUMPER REINFORCEMENT
Install the rear No. 2 bumper reinforcement with the 2 bolts.
52156A
6.INSTALL REAR BUMPER SIDE SUPPORT LH
Attach the 6 claws to install the rear bumper side support LH.
Install the 3 screws.
52155A
7.INSTALL REAR BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
52563D
8.INSTALL REAR UPPER BUMPER RETAINER LH
Attach the 2 clips to install the rear upper bumper retainer LH.
52562E
9.INSTALL REAR UPPER BUMPER RETAINER RH
Use the same procedure described for the LH side.
81560
10.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
81550
11.INSTALL REAR COMBINATION LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52159
12.INSTALL REAR BUMPER COVER
For the rear bumper cover with tire carrier, use the procedures described below.
w/ TOYOTA Parking Assist-sensor System or w/ Rear Fog Light:
Connect the No. 2 frame wire connector.
Attach the 14 claws to install the rear bumper cover.
Install the 7 bolts, 6 screws and 2 clips.
Open the tail gate and install the 4 clips.
Close the tail gate.
52162B
13.INSTALL REAR NO. 1 BUMPER PLATE
Attach the 20 claws to install the rear No. 1 bumper plate.
76626E
14.INSTALL REAR QUARTER PANEL MUDGUARD LH
76625G
15.INSTALL REAR QUARTER PANEL MUDGUARD RH
51903B
16.INSTALL SPARE WHEEL CARRIER SUB-ASSEMBLY (w/ Tire Carrier)
51902A
17.INSTALL SPARE WHEEL COVER SUB-ASSEMBLY (w/ Tire Carrier)
51937C
18.INSTALL SPARE WHEEL CARRIER HINGE BRACKET (w/ Tire Carrier)
51980A
19.INSTALL PINTLE HOOK ASSEMBLY
Install the pintle hook assembly and pintle hook bracket with the 2 bolts, 2 eyelet pintle hooks and 4 nuts.
For vehicles with a spare installed to the underbody, install the spare tire.