51980A
1.REMOVE PINTLE HOOK ASSEMBLY
For vehicles with a spare tire installed to the underbody, remove the spare tire.
| *1 | Eyelet Pintle Hook |
| *2 | Pintle Hook Bracket |
Remove the 4 nuts.
Remove the 2 bolts, 2 eyelet pintle hooks, pintle hook assembly and pintle hook bracket.
51937C
2.REMOVE SPARE WHEEL CARRIER HINGE BRACKET (w/ Tire Carrier)
51902A
3.REMOVE SPARE WHEEL COVER SUB-ASSEMBLY (w/ Tire Carrier)
51903B
4.REMOVE SPARE WHEEL CARRIER SUB-ASSEMBLY (w/ Tire Carrier)
76626E
5.REMOVE REAR QUARTER PANEL MUDGUARD LH
76625G
6.REMOVE REAR QUARTER PANEL MUDGUARD RH
52162B
7.REMOVE REAR NO. 1 BUMPER PLATE
Put protective tape around the rear No. 1 bumper plate.
Detach the 20 claws and remove the rear No. 1 bumper plate.
| *1 | Protective Tape | - | - |
52159
8.REMOVE REAR BUMPER COVER
For the rear bumper cover with tire carrier, use the procedures described below.
Put protective tape around the rear bumper cover.
| *1 | Protective Tape | - | - |
Open the tail gate and remove the 4 clips.
Close the tail gate.
Remove the 7 bolts, 6 screws and 2 clips.
Detach the 14 claws and remove the rear bumper cover.
w/ TOYOTA Parking Assist-sensor System or w/ Rear Fog Light:
Disconnect the No. 2 frame wire connector.
81560
9.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
81550
10.REMOVE REAR COMBINATION LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52563D
11.REMOVE REAR UPPER BUMPER RETAINER LH
Detach the 2 clips and remove the rear upper bumper retainer LH.
52562E
12.REMOVE REAR UPPER BUMPER RETAINER RH
Use the same procedure described for the LH side.
52156A
13.REMOVE REAR BUMPER SIDE SUPPORT LH
Remove the 3 screws.
Detach the 6 claws and remove the rear bumper side support LH.
52155A
14.REMOVE REAR BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
52172B
15.REMOVE REAR NO. 2 BUMPER REINFORCEMENT
Remove the 2 bolts and rear No. 2 bumper reinforcement.
57615C
16.REMOVE REAR BUMPER ARM BRACKET
Remove the bolt and rear bumper arm bracket.
Use the same procedure to remove the rear bumper arm bracket on the other side.
57616B
17.REMOVE REAR BUMPER ARM BRACKET LH
Disconnect the connector.
Remove the 2 bolts and rear bumper arm bracket LH.
58724B
18.REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Remove the 2 screws, 2 grommets and No. 2 luggage compartment side cover protector.
58723B
19.REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Use the same procedure described for the LH side.