Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Window Frame Moulding | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body and window frame moulding excessively.
75756C
1.INSTALL FRONT DOOR REAR WINDOW FRAME MOULDING LH
Clean the vehicle body surface.
Using a heat light, heat the vehicle body surface.
Remove the double-sided tape from the vehicle body surface.
Wipe off any tape adhesive residue with cleaner.
Install a new window frame moulding.
Using a heat light, heat a new window frame moulding and the vehicle body surface.
Remove the peeling paper from the face of the window frame moulding.
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
Attach the clip and double-sided tape to install the window frame moulding.
Press the window frame moulding firmly to install it.
75720
2.INSTALL FRONT DOOR BELT MOULDING ASSEMBLY LH
68151E
3.INSTALL FRONT DOOR GLASS RUN LH
68102
4.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
68172A
5.INSTALL FRONT INNER DOOR GLASS WEATHERSTRIP LH
67832
6.INSTALL FRONT DOOR SERVICE HOLE COVER LH
87940
7.INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
67602
8.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
74646
9.INSTALL DOOR ASSIST GRIP COVER LH
74240A
10.INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH
69278B
11.INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH
67492A
12.INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH
13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).