Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR WINDOW FRAME MOULDING › from 2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255844 REAR DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR WINDOW FRAME MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When installing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.



Standard Heating Temperature:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body and window frame moulding excessively.


PROCEDURE

Hide 75762A 1.INSTALL REAR DOOR FRONT WINDOW FRAME MOULDING LH

a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove the double-sided tape from the vehicle body surface.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new window frame moulding.

i.

Using a heat light, heat a new window frame moulding and the vehicle body surface.


ii.

Remove the peeling paper from the face of the window frame moulding.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



iii.
B182609E08
0.521,1.823 1.396,2.208 1.396,2.208 1.396,2.844 false 0.875,2.854 2.104,3.177 1.229,0.323 10 false Double-sided Tape

Attach the clip and double-sided tape to install the window frame moulding.

HINT:

Press the window frame moulding firmly to install it.




Hide 75740 2.INSTALL REAR DOOR BELT MOULDING ASSEMBLY LH

Hide 68104 3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 68124C 4.INSTALL REAR DOOR QUARTER WINDOW GLASS LH

Hide 67408F 5.INSTALL REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

Hide 68152C 6.INSTALL REAR DOOR GLASS RUN LH

Hide 67842E 7.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 68174C 8.INSTALL REAR INNER DOOR GLASS WEATHERSTRIP LH

Hide 67604 9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 10.INSTALL ASSIST GRIP COVER LH

Hide 74280 11.INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

Hide 69278C 12.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).