Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR WINDOW FRAME MOULDING › from 2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255844 REAR DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR WINDOW FRAME MOULDING  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When removing window frame moulding, heat the vehicle body and window frame moulding using a heat light.



Standard Heating Temperature:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Window Frame Moulding 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body and window frame moulding excessively.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 69278C 3.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

Hide 74280 4.REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

Hide 74611C 5.REMOVE ASSIST GRIP COVER LH

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 68174C 7.REMOVE REAR INNER DOOR GLASS WEATHERSTRIP LH

Hide 67842E 8.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 68152C 9.REMOVE REAR DOOR GLASS RUN LH

Hide 67408F 10.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

Hide 68124C 11.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

Hide 68104 12.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

Hide 75740 13.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH

Hide 75762A 14.REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING LH

B182609E05
1.125,0.302 1.01,0.302 1.01,0.302 0.833,0.781 false 0.552,1.844 1.375,2.198 1.375,2.198 1.375,2.875 false 0.885,2.896 2.115,3.219 1.229,0.323 10 false Double-sided Tape 1.167,0.219 2.208,0.5 1.042,0.281 10 false Protective Tape

a.

Put protective tape around the window frame moulding.


b.

Detach the clip and remove the double-sided tape to remove the window frame moulding.