When removing the back door garnish, heat the back door garnish and vehicle body using a heat light.
| Item | Temperature |
|---|---|
| Back Door Garnish | 20 to 30°C (68 to 86°F) |
| Vehicle Body | 40 to 60°C (104 to 140°F) |
Do not heat the back door garnish and vehicle body excessively.
76801B
1.REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE RH
Put protective tape around the back door garnish.
Detach the 7 clips and remove the double-sided tape to remove the back door garnish.
75741E
2.REMOVE SYMBOL EMBLEM
58574A
3.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE
64894
4.REMOVE BACK DOOR TRIM COVER LH
64893
5.REMOVE BACK DOOR TRIM COVER RH
64780A
6.REMOVE BACK DOOR TRIM PANEL ASSEMBLY
76802C
7.REMOVE NO. 2 BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
Remove the 2 nuts and disconnect the connector.
Put protective tape around the No. 2 back door garnish.
Detach the 8 clips.
Pull out the wire harness of the license plate light from the tail gate, and remove the No. 2 back door garnish.
81270
8.REMOVE LICENSE PLATE LIGHT ASSEMBLY
75132C
9.REMOVE REAR LICENSE LIGHT COVER