Use the following procedure to troubleshoot the wiper and washer system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the Problem Symptoms Table.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM(w/o Rain Sensor)>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Data List / Active Test.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM(w/o Rain Sensor)>DATA LIST / ACTIVE TEST
Terminals of ECU.
Click hereVehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM(w/o Rain Sensor)>TERMINALS OF ECU
Inspection.
On-vehicle inspection.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT