Use these following procedures to troubleshoot the tail gate closer system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD) | B |
| CAN DTC is output (for RHD) | C |
A
B
C
Starting with the lower tail gate closed, open and close the lower tail gate 6 times.
Check for DTCs.
Click hereVehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DTC CHECK / CLEAR
Clear the DTCs.
Click hereVehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DTC CHECK / CLEAR
Starting with the lower tail gate closed, open and close the lower tail gate 6 times.
Recheck for DTCs.
Click hereVehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Refer to Problem Symptoms Table.
Click hereVehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Operation Check.
Click hereVehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>OPERATION CHECK
Terminals of ECU.
Click hereVehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>TERMINALS OF ECU
Data List / Active Test.
Click hereVehicle Exterior>DOOR / HATCH>TAIL GATE CLOSER SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT