Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System)
RM2660E _58 Vehicle Interior _052838 DOOR LOCK _0255548 WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System) Y

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

The wireless door lock control system troubleshooting procedures are based on the premise that the following systems are operating normally. Check these systems first before troubleshooting the wireless door lock control system.

-

Power door lock control system

-

Power window control system

-

Sliding roof system


·

Use these procedures to troubleshoot the wireless door lock control system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC*
3.CHECK FOR DTC*


c.

Recheck for DTCs (Click here Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System)>DTC CHECK / CLEAR). Based on the DTCs output above, try to force output of the same CAN communication system DTC, LIN communication system DTC or wireless door lock control system DTC by simulating the symptoms indicated by the DTC.


Result:
Result Proceed to
CAN DTC is not output A
CAN communication system (for LHD) DTC is output B
CAN communication system (for RHD) DTC is output C
LIN communication system DTC is output D
Wireless door lock control system DTC is output E



A

4.PROBLEM SYMPTOMS TABLE

B

GO TO CAN COMMUNICATION SYSTEM

Click here NETWORKING > CAN COMMUNICATION SYSTEM (for LHD) > DIAGNOSIS SYSTEM


C

GO TO CAN COMMUNICATION SYSTEM

Click here NETWORKING > CAN COMMUNICATION SYSTEM (for RHD) > DIAGNOSIS SYSTEM


D

E

4.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

5.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

6.REPAIR OR REPLACE
6.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END