Use the following procedures to troubleshoot the wide view front monitor system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage with the engine switch off.
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the navigation system.
| Result | Proceed to |
|---|---|
| Navigation system is normal | A |
| Navigation system is abnormal | B |
A
B
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD) | B |
| CAN DTC is output (for RHD) | C |
A
B
C
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the side monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.
| Result | Proceed to |
|---|---|
| Parking Assist Monitor System (w/ Side Monitor System) | ( )
|
| Side Monitor System | ( )
|
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| DTC is output | B |
A
B
Refer to the Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Terminals of ECU.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>WIDE VIEW FRONT MONITOR SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT