Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(w/ Navigation System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052828 AUDIO / VIDEO _0255478 AUDIO AND VISUAL SYSTEM(w/ Navigation System) Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(w/ Navigation System)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the audio and visual system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the engine switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


Result:
Proceed to
NEXT



NEXT

3.DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION
3.DIAGNOSTIC QUESTIONING AND SYMPTOM CONFIRMATION
a.

Ask the customer about symptoms and confirm malfunctions.


Result:
Result Proceed to
Other symptoms occurred. A
The screen displays nothing. B



A

4.OPERATION CHECK

B

6.CHECK FOR DTC*
4.OPERATION CHECK

Result:
Result Proceed to
Symptom is not normal operation. A
Symptom is normal operation. B



A

5.CHECK CAN COMMUNICATION SYSTEM*

B

SYMPTOM IS NORMAL OPERATION

5.CHECK CAN COMMUNICATION SYSTEM*

Result:
Result Proceed to
CAN DTCs are not output. A
CAN DTCs are output (for LHD). B
CAN DTCs are output (for RHD). C



A

6.CHECK FOR DTC*

B

C

6.CHECK FOR DTC*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/ Navigation System)>DTC CHECK / CLEAR

Result:
Result Proceed to
DTCs are output. A
DTCs are not output.(The multi-display assembly displays content.) B
DTCs are not output.(The multi-display assembly does not display anything.) C


HINT:

If more information is needed, perform a check using the "System Check Mode" screen after checking for DTCs using the intelligent tester.




A

7.CLEAR DTC*

B

10.CHECK HARD DISK DRIVE

C

11.PROBLEM SYMPTOMS TABLE
7.CLEAR DTC*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/ Navigation System)>DTC CHECK / CLEAR

HINT:

The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.



Result:
Proceed to
NEXT



NEXT

8.RECHECK FOR DTC*
8.RECHECK FOR DTC*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/ Navigation System)>DTC CHECK / CLEAR

Result:
Result Proceed to
DTCs are output. A
DTCs are not output. B


HINT:
·

Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.

·

If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the intelligent teste.

·

Check the DTCs and inspect the area that the code indicates.





A

9.DIAGNOSTIC TROUBLE CODE CHART

B

10.CHECK HARD DISK DRIVE
9.DIAGNOSTIC TROUBLE CODE CHART
a.

Find the output code in Diagnostic Trouble Code Chart.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/ Navigation System)>DIAGNOSTIC TROUBLE CODE CHART

NOTICE:
·

The audio and visual system (w/ Navigation System) outputs DTCs for the following system.

·

When DTCs other than those in Diagnostic Trouble Code Chart for the audio and visual system (w/ Navigation System) are output, refer to Diagnostic Trouble Code Chart for the relevant system.




Result:
Result Proceed to
DTCs for the audio and visual system are output. A
DTCs for the navigation system are output. B
DTCs for the rear seat entertainment system are output. C



A

13.CHECK CIRCUIT

B

C

10.CHECK HARD DISK DRIVE
a.

Enter the "Failure Diagnosis" screen. Refer to Check Hard Disk Drive in Operation Check.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/ Navigation System)>OPERATION CHECK

OK:

"OK" is displayed.



Result:
Proceed to
OK
NG



OK

11.PROBLEM SYMPTOMS TABLE

NG

REPLACE HARD DISC

11.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM(w/ Navigation System)>PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table. A
Fault is listed in Problem Symptoms Table. B


HINT:

If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING




A

12.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

B

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

12.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

NEXT

13.CHECK CIRCUIT
13.CHECK CIRCUIT
a.

Adjust, repair or replace as necessary.


Result:
Proceed to
NEXT



NEXT

14.RECHECK FOR DIAGNOSTIC TROUBLE CODE
14.RECHECK FOR DIAGNOSTIC TROUBLE CODE
HINT:

After clearing DTCs, recheck for DTCs.


Result:
Proceed to
NEXT



NEXT

15.PERFORM CONFIRMATION TEST
15.PERFORM CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END