Home › Vehicle Exterior › MIRROR (EXT) › POWER MIRROR CONTROL SYSTEM(w/ Retract Mirror) › from 2015.08
RM2660E _59 Vehicle Exterior _052853 MIRROR (EXT) _0255766 POWER MIRROR CONTROL SYSTEM(w/ Retract Mirror) Y

MIRROR (EXT)  POWER MIRROR CONTROL SYSTEM(w/ Retract Mirror)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedures to troubleshoot the power mirror control system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
3.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN communication system is functioning normally.


Result:
Result Proceed to
CAN DTC is not output A
CAN DTC is output (for LHD w/ Central Gateway ECU) B
CAN DTC is output (for LHD w/o Central Gateway ECU) C
CAN DTC is output (for RHD w/ Central Gateway ECU) D
CAN DTC is output (for RHD w/o Central Gateway ECU) E



A

4.PROBLEM SYMPTOMS TABLE

B

C

D

E

4.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

5.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

6.ADJUST, REPAIR OR REPLACE
5.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

6.ADJUST, REPAIR OR REPLACE
6.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

7.CONFIRMATION TEST
7.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END