Use the following procedures to troubleshoot the VGRS system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check if the CAN communication system is functioning normally.
for LHD with Central Gateway ECU:
for LHD without Central Gateway ECU:
for RHD with Central Gateway ECU:
for RHD without Central Gateway ECU:
| Result | Proceed to |
|---|---|
| CAN DTCs are not output | A |
| CAN DTCs are output (for LHD with Central Gateway ECU) | B |
| CAN DTCs are output (for LHD without Central Gateway ECU) | C |
| CAN DTCs are output (for RHD with Central Gateway ECU) | D |
| CAN DTCs are output (for RHD without Central Gateway ECU) | E |
A
B
C
D
E
Check for DTCs.
Click hereSteering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR
Clear the DTCs.
Click hereSteering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs.
Click hereSteering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR
Simulate the malfunction and check if the DTCs are output again.
Click hereSteering>VARIABLE GEAR RATIO STEERING>VARIABLE GEAR RATIO STEERING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output | B |
| DTCs are not output, and the malfunction cannot be simulated or checked. | C |
A
B
C
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT