Use the following procedures to troubleshoot the TOYOTA parking assist-sensor system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output. | A |
| CAN DTC is output (for LHD). | B |
| CAN DTC is output (for RHD). | C |
A
B
C
Recheck for DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output (Problem symptom occurs). | A |
| DTCs are not output (Problem symptom does not occur). | B |
| DTCs are output. | C |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
C
Refer to the Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table. | A |
| Fault is listed in problem symptoms table. | B |
A
B
Operation Check.
Terminals of ECU.
Data List / Active Test.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT