Use the following procedures to troubleshoot the front power seat control system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD (w/ Central Gateway ECU)) | B |
| CAN DTC is output (for LHD (w/o Central Gateway ECU)) | C |
| CAN DTC is output (for RHD (w/ Central Gateway ECU)) | D |
| CAN DTC is output (for RHD (w/o Central Gateway ECU)) | E |
A
B
C
D
E
Refer to the Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List / Active Test
Terminals of ECU
Operation Check
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT