Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255402 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2162/62  Communication Line Switch  


DESCRIPTION

There is a switch inside the tire pressure ECU and receiver. The system switches to the tire pressure warning system function when an IG ON signal is received and switches to the wireless door lock control system (w/o Entry and Start System) function when an IG OFF signal is received. If the system does not switch to the tire pressure warning system function when an IG ON signal is received, DTC C2162/62 is stored.

DTC No. DTC Detection Condition Trouble Area
C2162/62 The system does not switch to the wireless door lock control system (w/o Entry and Start System) or tire pressure warning system inside the tire pressure warning ECU and receiver. Tire pressure warning ECU and receiver

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (Click here Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (Click here Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



PROCEDURE

1.CHECK DTC OUTPUT (C2162/62)

b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON.


d.

Check for DTCs.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR

OK:

DTC C2162/62 is not output.


Result:
Proceed to
OK
NG




OK

NG

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER