Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255402 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2176/76  Receiver Error  


DESCRIPTION

The signals are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves.

DTC No. DTC Detection Condition Trouble Area
C2176/76 Malfunction in the tire pressure warning ECU and receiver internal circuit Tire pressure warning ECU and receiver

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



PROCEDURE

1.CHECK DTC OUTPUT (C2176/76)

b.

Turn the ignition switch off.


c.

Turn the ignition switch to ON and check for DTCs (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).

OK:

DTC C2176/76 is not output.




OK

END

NG

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER