Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER(for Double Swing Out Type) › from 2016.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255855 REAR BUMPER(for Double Swing Out Type) A

EXTERIOR PANELS / TRIM  REAR BUMPER(for Double Swing Out Type)  REASSEMBLY  


PROCEDURE

Hide 51776B 1.INSTALL REAR NO. 2 STEP COVER (w/ Towing Hitch)

a.

Attach the 4 claws to install the rear No. 2 step cover.


b.

Install the 2 screws and 2 clips.


Hide 52169C 2.INSTALL REAR LOWER BUMPER COVER (w/ Towing Hitch)

a.

Install the rear lower bumper cover with the clip.


Hide 51776B 3.INSTALL REAR NO. 2 STEP COVER (w/ Pintle Hook)

a.

Attach the 10 claws to install the rear No. 2 step cover.


Hide 52463 4.INSTALL REAR BUMPER PAD LH

HINT:

When installing the rear bumper pad, heat the rear bumper cover using a heat light.


Standard:
Item Temperature
Rear Bumper Cover 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the rear bumper cover excessively.


a.

When using a new rear bumper cover:

i.

Clean the surface of a new rear bumper cover.


ii.

Using a heat light, heat the rear bumper cover surface.



b.

When reusing the rear bumper cover:

i.

Using a heat light, heat the rear bumper cover surface.


ii.

Remove the double-sided tape from the rear bumper cover.


iii.

Wipe off any tape adhesive residue with cleaner.



c.
B292677

Install a new rear bumper pad.

i.

Remove the peeling paper from the face of a new rear bumper pad.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.



ii.

Align the rear bumper pad with the mark-off line of the rear bumper.


iii.

Install the rear bumper pad.



Hide 52462 5.INSTALL REAR BUMPER PAD RH

HINT:

Use the same procedure described for the LH side.


Hide 81490C 6.INSTALL REAR FOG LIGHT ASSEMBLY LH (w/ Rear Fog Light)

Hide 81680 7.INSTALL BACK-UP LIGHT ASSEMBLY LH (w/o Rear Fog Light)

Hide 81670 8.INSTALL BACK-UP LIGHT ASSEMBLY RH

HINT:

Use the same procedure described for the LH side.


Hide 52187C 9.INSTALL REAR BUMPER NO. 2 SIDE BRACKET (w/ Tire Carrier)

a.

Attach the 3 claws to install the rear bumper No. 2 side bracket.


Hide 52189B 10.INSTALL REAR BUMPER NO. 3 SIDE BRACKET (w/ Tire Carrier)

a.

Install the rear bumper No. 3 side bracket with the 2 screws.


Hide 52166A 11.INSTALL REAR BUMPER UPPER COVER LH

a.

Attach the 4 claws to install the rear bumper upper cover.


Hide 52165A 12.INSTALL REAR BUMPER UPPER COVER RH

HINT:

Use the same procedure described for the LH side.


Hide 52615 13.INSTALL REAR BUMPER ENERGY ABSORBER

a.

Attach the 8 claws to install the rear bumper energy absorber.


Hide 82165 14.INSTALL NO. 2 FRAME WIRE

a.

Attach the 13 clamps to install the No. 2 frame wire.


b.

Connect the 2 connectors.