Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81490C
1.INSTALL REAR FOG LIGHT ASSEMBLY LH
except Double Swing Out Type:
Install the rear fog light assembly LH with the 3 screws.
Connector the connector and attach the wire harness clamp.
for Double Swing Out Type:
Attach the claw to install the rear fog light assembly LH.
Install the 2 nuts.
Connector the connector.
2.INSTALL REAR BUMPER
for Double Swing Out Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(for Double Swing Out Type)>INSTALLATION
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(for Standard)>INSTALLATION
w/ Pintle Hook:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(w/ Pintle Hook)>INSTALLATION