The ECM monitors the input signals of the Throttle Position (TP) sensor No. 1 and stop light switch. As the ECM monitors the input signals of the TP sensor No. 1 and the STP signals of the stop light switch, if the input signals and control signals are deviated, a DTC is stored.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| P060E | When either condition below is met:
·
An ECM main CPU error. ·
An ECM sub CPU error. |
ECM |
Turn the engine switch off.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Turn the engine switch on (IG).
Check DTC.
P060E is not output.
OK
NG