Home › Engine / Hybrid System › 3UR-FE (ENGINE CONTROL) › SFI SYSTEM(w/ Secondary Air Injection System) › from 2017.08
RM2660E _51 Engine / Hybrid System _052775 3UR-FE ENGINE CONTROL _0327320 SFI SYSTEM(w/ Secondary Air Injection System) C

3UR-FE ENGINE CONTROL  SFI SYSTEM(w/ Secondary Air Injection System)  P2102  Throttle Actuator Control Motor Circuit Low  P2103  Throttle Actuator Control Motor Circuit High  


DESCRIPTION

The throttle actuator is operated by the ECM and opens and closes the throttle valve using gears.

The opening angle of the throttle valve is detected by the Throttle Position (TP) sensor, which is mounted on the throttle body. The TP sensor provides feedback to the ECM. This feedback allows the ECM to appropriately control the throttle actuator and monitor the throttle opening angle as the ECM responds to driver inputs.

HINT:

This ETCS (Electronic Throttle Control System) does not use a throttle cable.

DTC Code DTC Detection Condition Trouble Area
P2102 Conditions (a) and (b) continue for 2.0 seconds (1 trip detection logic):
(a) The throttle actuator duty ratio is 80% or more.
(b) The throttle actuator current is below 0.5 A.
·

Open in throttle actuator circuit

·

Throttle actuator

·

ECM


P2103 Either of the following conditions is met (1 trip detection logic):
·

A hybrid IC diagnosis signal failure.

·

A hybrid IC current limiter port failure.


·

Short in throttle actuator circuit

·

Throttle actuator

·

Throttle valve

·

Throttle body assembly

·

ECM




MONITOR DESCRIPTION

The ECM monitors the electrical current through the electronic actuator, and detects malfunctions and open circuits in the throttle actuator based on this value. If the current is outside the standard range, the ECM determines that there is a malfunction in the throttle actuator. In addition, if the throttle valve does not function properly (for example, stuck on), the ECM determines that there is a malfunction. The ECM then illuminates the MIL and stores DTC(s).

Example:

When the electrical current is below 0.5 A and the throttle actuator duty ratio exceeds 80%, the ECM interprets this as the current being outside the standard range, illuminates the MIL and stores DTC(s).

If the malfunction is not repaired successfully, a DTC is stored when the engine is quickly revved to a high rpm several times after the engine is started and has idled for 5 seconds.

FAIL-SAFE

When either of these DTCs, or other DTCs relating to ETCS (Electronic Throttle Control System) malfunctions are stored, the ECM enters fail-safe mode. During fail-safe mode, the ECM cuts the current to the throttle actuator, and the throttle valve is returned to a 7° throttle angle by the return spring. The ECM then adjusts the engine output by controlling the fuel injection (intermittent fuel cut) and ignition timing, in accordance with the accelerator pedal opening angle, to allow the vehicle to continue at a minimal speed. If the accelerator pedal is depressed firmly and gently, the vehicle can be driven slowly.

Fail-safe mode continues until a pass condition is detected, and the engine switch is then turned off.

WIRING DIAGRAM

A162853E13
5.772,3.144 6.108,3.300 0.336,0.156 10 ECM 5.398,0.944 6.461,1.313 1.063,0.369 10 Throttle Actuator Control Circuit 4.884,0.87 5.124,1.044 0.239,0.174 10 M+ 4.884,1.622 5.073,1.782 0.188,0.160 10 M- 1.182,0.866 1.421,1.040 0.239,0.174 10 M+ 1.206,1.617 1.394,1.778 0.188,0.160 10 M- 5.774,3.005 6.104,3.161 0.330,0.156 10 C45 4.64,0.87 4.856,1.026 0.216,0.156 10 20 4.64,1.618 4.856,1.774 0.216,0.156 10 19 4.64,2.388 4.856,2.544 0.216,0.156 10 42 2.709,2.247 3.282,2.413 0.573,0.165 10 Shielded 0.273,2.316 1.331,2.486 1.059,0.170 10 Throttle Actuator 0.273,2.158 0.484,2.316 0.211,0.158 10 C3 1.452,0.867 1.559,1.037 0.107,0.170 10 2 1.44,1.614 1.547,1.784 0.107,0.170 10 1 4.902,2.465 5.294,2.641 0.392,0.177 10 GE01

CAUTION / NOTICE / HINT

HINT:
·

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.


·

The throttle actuator current (Throttle Motor Current) and the throttle actuator duty ratio (Throttle Motor Open Duty / Throttle Motor Close Duty) can be read using the intelligent tester. However, the ECM shuts off the throttle actuator current when the ETCS malfunctions.



PROCEDURE

1.INSPECT THROTTLE BODY ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR)
A150305E03
0.074,0.196 2.612,0.588 2.538,0.392 10 Component without harness connected: (Throttle Body) 1.931,2.455 2.208,2.629 0.277,0.173 10 M+ 2.563,2.455 2.841,2.629 0.277,0.173 10 M- 2.24,1.946 2.103,2.401 false 2.532,1.937 2.61,2.401 false

a.

Disconnect the C3 throttle body connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (M+) - 1 (M-) 20°C (68°F) 0.3 to 100 Ω




OK

2.CHECK HARNESS AND CONNECTOR (THROTTLE ACTUATOR - ECM)

NG

2.CHECK HARNESS AND CONNECTOR (THROTTLE ACTUATOR - ECM)
a.

Disconnect the C3 throttle body connector.


b.

Disconnect the C45 ECM connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C3-2 (M+) - C45-20 (M+) Always Below 1 Ω
C3-1 (M-) - C45-19 (M-) Always Below 1 Ω
C3-2 (M+) or C45-20 (M+) - Body ground Always 10 kΩ or higher
C3-1 (M-) or C45-19 (M-) - Body ground Always 10 kΩ or higher




OK

3.INSPECT THROTTLE BODY ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT THROTTLE BODY ASSEMBLY
a.

Check for foreign objects between the throttle valve and the housing.

OK:

No foreign objects between throttle valve and housing.




OK

4.INSPECT THROTTLE VALVE

NG

REMOVE FOREIGN OBJECT AND CLEAN THROTTLE BODY

4.INSPECT THROTTLE VALVE
a.

Check if the throttle valve opens and closes smoothly.

OK:

Throttle valve opens and closes smoothly.




OK

NG