1.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY
Remove the exhaust manifold (See page Engine / Hybrid System>3UR-FE (INTAKE / EXHAUST)>EXHAUST MANIFOLD>REMOVAL).
17111
2.REMOVE INTAKE MANIFOLD
Remove the intake manifold (See page Engine / Hybrid System>3UR-FE (INTAKE / EXHAUST)>INTAKE MANIFOLD>REMOVAL).
16261G
3.DISCONNECT NO. 1 WATER BY-PASS HOSE
Slide the clip and disconnect the No. 1 water by-pass hose from the water by-pass joint and water inlet housing.
| *1 | No. 1 Water By-pass Hose |
| *2 | No. 2 Water By-pass Hose |
16264D
4.DISCONNECT NO. 2 WATER BY-PASS HOSE
Slide the clip and disconnect the No. 2 water by-pass hose from the water by-pass joint.
16268A
5.DISCONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY
Remove the 3 bolts and disconnect the No. 2 water by-pass pipe sub-assembly.
11212
6.REMOVE NO. 2 ENGINE COVER
77285H
7.DISCONNECT FUEL TUBE CLAMP
Disconnect the fuel tube clamp from the bracket.
12611
8.REMOVE NO. 1 ENGINE COVER
16355
9.REMOVE FRONT WATER BY-PASS JOINT
Disconnect the engine coolant temperature sensor connector.
Remove the 4 nuts, front water by-pass joint and 2 gaskets.
17303
10.REMOVE AIR PIPE SUB-ASSEMBLY
Slide the clip and disconnect the No. 2 hose from the air pipe sub-assembly.
| *1 | No. 2 Hose |
| *2 | No. 3 Hose |
Slide the clip and disconnect the No. 3 hose from the air pipe sub-assembly.
Disconnect the air pump connector.
Disconnect the air pump connector clamp holder.
Using a clip remover, detach the wire harness claw.
Remove the 2 bolts and air pipe sub-assembly.
Disconnect the 2 No. 1 air hoses from the air pipe sub-assembly.
25720
11.REMOVE AIR SWITCHING VALVE ASSEMBLY
Disconnect the knock sensor connector.
Remove the bolt and bracket.
Disconnect the 2 air switching valve connectors.
Remove the 3 bolts and air switching valve assembly.
17362
12.REMOVE NO. 2 AIR TUBE
Remove the 2 bolts, No. 2 air tube and gasket.
Be careful not to damage the installation surface of the gaskets.
17363Q
13.REMOVE NO. 3 AIR TUBE
Remove the 2 bolts, No. 3 air tube and gasket.
Be careful not to damage the installation surface of the gaskets.