53806
1.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
53805
2.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
51441
3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
51442
4.REMOVE NO. 2 ENGINE UNDER COVER
53736G
5.REMOVE FRONT FENDER APRON SEAL FRONT RH
Using a clip remover, remove the 3 clips and front fender apron seal front RH.
53738A
6.REMOVE FRONT FENDER APRON SEAL REAR RH
Using a clip remover, remove the 4 clips and front fender apron seal rear RH.
53737B
7.REMOVE FRONT FENDER APRON SEAL LH
Using a clip remover, remove the 3 clips and front fender apron seal LH.
53739A
8.REMOVE FRONT FENDER APRON SEAL REAR LH
Using a clip remover, remove the 4 clips and front fender apron seal rear LH.
11452
9.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
17430
10.REMOVE TAILPIPE ASSEMBLY
17420
11.REMOVE CENTER EXHAUST PIPE ASSEMBLY
17450B
12.REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
17410
13.REMOVE FRONT EXHAUST PIPE ASSEMBLY
37117
14.REMOVE PROPELLER SHAFT HEAT INSULATOR
Remove the 2 bolts and propeller shaft heat insulator.
17119
15.REMOVE NO. 2 MANIFOLD STAY
Remove the 3 bolts and No. 2 manifold stay.
17168
16.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and No. 2 exhaust manifold heat insulator.
17105
17.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
Disconnect the connector and detach the wire harness clamp.
w/ Secondary Air Injection System:
Remove the 10 nuts, exhaust manifold sub-assembly LH and 2 gaskets.
w/o Secondary Air Injection System:
Remove the 8 nuts, exhaust manifold sub-assembly LH and gasket.
17118
18.REMOVE NO. 1 MANIFOLD STAY
Remove the 3 bolts and No. 1 manifold stay.
17167
19.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and No. 1 exhaust manifold heat insulator.
17104
20.REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
Disconnect the connector and detach the wire harness clamp.
w/ Secondary Air Injection System:
Remove the 10 nuts, exhaust manifold sub-assembly RH and 2 gaskets.
w/o Secondary Air Injection System:
Remove the 8 nuts, exhaust manifold sub-assembly RH and gasket.
89467B
21.REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
89467C
22.REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)