During test mode, when the tire pressure warning reset switch is on, the tire pressure warning light comes on, and when the tire pressure warning reset switch is off, the tire pressure warning light blinks at 0.125 second intervals.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C2198/98 | Test mode procedure is performed. | ·
Tire pressure warning reset switch ·
Wire harness or connector ·
Tire pressure warning ECU and receiver |
When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.
It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
Remove the tire pressure warning reset switch connector (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING RESET SWITCH>REMOVAL).
Inspect the tire pressure warning reset switch connector (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING RESET SWITCH>INSPECTION).
OK
NG
Turn the ignition switch off.
Disconnect the L65 tire pressure warning ECU and receiver connector.
Disconnect the E116 tire pressure warning reset switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L65-3 (CLSW) - E116-1 (INT) | Always | Below 1 Ω |
| L65-3 (CLSW) or E116-1 (INT) - Body ground | Always | 10 kΩ or higher |
| E116-2 (E) - Body ground | Always | Below 1 Ω |
OK
NG