Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2019.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255402 TIRE PRESSURE WARNING SYSTEM J

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  ECU Power Source Circuit  


DESCRIPTION

This is the power source for the tire pressure warning ECU and receiver.

WIRING DIAGRAM

C281617E10
5.219,2.479 6.719,2.698 1.5,0.219 10 false L65 5.219,2.667 6.688,3.052 1.469,0.385 10 false Tire Pressure Warning ECU and Receiver 5.417,0.771 5.635,1.031 0.219,0.26 10 false IG 5.417,1.854 5.792,2.063 0.375,0.208 10 false GND 5.198,0.677 5.344,0.927 0.146,0.25 10 false 1 5.135,1.771 5.323,1.99 0.188,0.219 10 false 12 3.51,0.958 4.729,1.208 1.219,0.25 10 false ECU-IG NO. 2 1.302,0.802 2.458,1.042 1.156,0.24 10 false from IG Circuit

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

·

It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.



HINT:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ECU - BATTERY AND BODY GROUND)
a.
C420888E03
0.208,0.729 0.625,1.042 0.417,0.313 0.938,1.771 1.198,1.219 false 2.469,1.896 2.177,1.49 false 0.292,0.792 0.625,0.99 0.333,0.198 11 false L65 0.813,1.823 1.125,2.021 0.313,0.198 10 false IG 2.438,1.917 2.896,2.115 0.458,0.198 10 false GND 0.083,0.052 0.396,0.25 0.313,0.198 10 false *a

Disconnect the L65 tire pressure warning ECU and receiver connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
L65-1 (IG) - Body ground Ignition switch ON 10 to 16 V
Ignition switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
L65-12 (GND) - Body ground] Always Below 1 Ω


Text in Illustration
*a Front view of wire harness connector
(to Tire Pressure Warning ECU and Receiver)



OK

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR