Home › Drivetrain › A750F (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION FLUID › 2015.08–2017.08
RM2660E _52 Drivetrain _052806 A750F AUTOMATIC TRANSMISSION / TRANSAXLE _0255279 AUTOMATIC TRANSMISSION FLUID A

A750F AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION FLUID  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE AUTOMATIC TRANSMISSION FLUID

a.

Lift the vehicle. [*1]

NOTICE:

Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure that the tilt angle from the front to rear of the vehicle is within +/-1°).



b.
C419315E01
2.865,1.927 2.865,1.75 2.865,1.75 3.042,1.25 true 1.99,0.208 2.25,0.208 2.25,0.208 2.865,1.083 true 1.583,3.635 1.938,2.646 1.938,2.646 2.188,2.646 true 0.844,4.292 0.844,3.875 true 1.552,0.104 2.01,0.344 0.458,0.24 10 false O-ring 2.583,1.948 3.385,2.24 0.802,0.292 10 false Refill Plug 2.229,2.552 3.26,2.823 1.031,0.271 10 false Overflow Plug 0.552,4.313 1.323,4.604 0.771,0.292 10 false Drain Plug

Remove the drain plug and gasket from the automatic transmission assembly to drain the automatic transmission fluid. [*2]


c.

Temporarily install the gasket and drain plug to the automatic transmission assembly. [*3]

HINT:

Reuse the old gasket. A new gasket will be installed in step [*16].



d.

Using a 5 mm hexagon socket wrench, remove the overflow plug and gasket from the automatic transmission assembly. [*4]


e.

Remove the refill plug and O-ring from the automatic transmission assembly. [*5]


f.

Add automatic transmission fluid to the refill hole until it flows out of the overflow hole. [*6]

NOTICE:
·

Use Toyota Genuine ATF WS.

·

Be sure to add automatic transmission fluid slowly. If automatic transmission fluid is added quickly, the automatic transmission fluid may hit internal parts and bounce back, resulting in automatic transmission fluid coming out of the refill hole.



C419313E01
1.531,0.458 1.823,0.458 1.823,0.458 2.385,1.271 true 4.396,2.229 4.635,2.229 4.635,2.229 5.302,1.552 true 0.854,0.365 1.531,0.615 0.677,0.25 10 false Refill Hole 3.51,2.135 4.396,2.396 0.885,0.26 10 false Overflow Hole


g.

Wait until the automatic transmission fluid flow slows and only drops come out. [*7]

C419314


h.

Using a 5 mm hexagon socket wrench. temporarily install the gasket and overflow plug to the automatic transmission assembly. [*8]

HINT:

Reuse the old gasket as the overflow plug will be removed again.



i.

Add the amount of specified to the refill hole. [*9]

Specified Amount of Fluid:

1.7 liters (1.8 US qts, 1.5 Imp. qts)


HINT:

If the specified amount of the automatic transmission fluid cannot be added, perform steps [*10] to [*14].



j.

Temporarily install the O-ring and refill plug to the automatic transmission assembly. [*10]

HINT:

Reuse the old O-ring as the refill plug will be removed again.



k.

Lower the vehicle. [*11]


l.

Start the engine. [*12]

NOTICE:

To reduce load, make sure that all electrical systems, such as the air conditioning, lighting system, electric fan and audio system, are off.



m.

Slowly move the shift lever from P to S, and then move the shift lever to P. [*13]


n.

Allow the engine to idle for 30 seconds to warm it up. [*14]


o.

Turn the engine switch off. [*15]


p.

Repeat steps [*1] to [*15].


q.

Repeat steps [*1] to [*2].


r.

Install a new gasket and the drain plug to the automatic transmission assembly. [*16]

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)


s.

Repeat steps [*4] to [*11].