Home › Suspension › SUSPENSION CONTROL › ACTIVE HEIGHT CONTROL FLUID
RM2660E _53 Suspension _052813 SUSPENSION CONTROL _0447249 ACTIVE HEIGHT CONTROL FLUID A

SUSPENSION CONTROL  ACTIVE HEIGHT CONTROL FLUID  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE ACTIVE HEIGHT CONTROL FLUID

a.
C176402

With the engine stopped, fill the reservoir tank with fluid.(*1)

HINT:

At this point, the vehicle height is low because the pressure of the cylinders is low.



b.

Start the engine and set the vehicle height to NORMAL.(*2)

NOTICE:

When the engine starts, the pump operates and fluid is supplied to each cylinder from the reservoir tank. Therefore, add the necessary amount of fluid so that the reservoir tank does not become empty.



c.

Stop the engine.(*3)


d.
C172939

Connect a hose to the bleeder plug of the front left side control valve, then loosen the bleeder plug.(*4)

CAUTION:

Be careful when loosening the control valve bleeder plug because the front vehicle height drops rapidly.



e.

Tighten the bleeder plug when no more air remains in the fluid and cloudiness is gone. (*5)

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


f.

Connect a hose to the bleeder plug of the front right side control valve, then loosen the bleeder plug.(*6)

CAUTION:

Be careful when loosening the control valve bleeder plug because the front vehicle height drops rapidly.



g.

Tighten the bleeder plug when no more air remains in the fluid and cloudiness is gone. (*7)

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


h.

Connect a hose to the bleeder plug of the rear left side or control valve, then loosen the bleeder plug. (*8)

CAUTION:

Be careful when loosening the control valve bleeder plug because the rear vehicle height drops rapidly.



i.

Tighten the bleeder plug when no more air remains in the fluid and cloudiness is gone. (*9)

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


j.

Connect a hose to the bleeder plug of the rear right side control valve, then loosen the bleeder plug. (*10)

CAUTION:

Be careful when loosening the control valve bleeder plug because the rear vehicle height drops rapidly.



k.

Tighten the bleeder plug when no more air remains in the fluid and cloudiness is gone. (*11)

Torque:
8.3 N*m (85 kgf*cm, 73 in.*lbf)


l.

Start the engine and set the vehicle height to NORMAL. (*12)

NOTICE:

When the engine starts, the pump operates and fluid is supplied to each cylinder from the reservoir tank. Therefore, add the necessary amount of fluid so that the reservoir tank does not become empty.



m.

Repeat steps from (*1) to (*12) until new fluid comes out.