| *A | for Power Tilt and Power Telescopic Steering Column | *B | for Manual Tilt and Manual Telescopic Steering Column |
1. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column)
2. STEERING WHEEL POSITION (for Manual Tilt and Manual Telescopic Steering Column)
|
Lower |
|
Extend |
Adjust steering wheel position by the below procedure.
1. Release the tilt and telescopic lever and fully extend and lower the steering column sub-assembly.
2. Lock the tilt and telescopic lever.
45024 3.REMOVE LOWER STEERING COLUMN COVER SUB-ASSEMBLY
|
|
|
Push Area |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) |
Turn the steering wheel and remove the 3 screws.
Press the part in the direction of the arrow shown in the illustration to detach the claw.
Detach the 2 claws and remove the lower steering column cover.
for Power Tilt and Power Telescopic Steering Column:
Do not damage the tilt and telescopic switch.
for Manual Tilt and Manual Telescopic Steering Column:
Do not damage the tilt and telescopic lever.
45286B 4.REMOVE UPPER STEERING COLUMN COVER
84650 5.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
|
Remove in this Direction | - | - |
Turn the steering wheel assembly to the right.
Using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.
If the claw is pulled with excessive force, it may break.