| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY | 47210L | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 2 | AIR DUCT SUB-ASSEMBLY | - | - | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 3 | BRAKE PEDAL STROKE SENSOR ASSEMBLY | 89510D | - | - | - |
| 4 | STOP LIGHT SWITCH MOUNTING ADJUSTER | 84345 | - | - | - |
| 5 | ENGINE ROOM MAIN WIRE | 82111 | - | - | - |
| 6 | BRAKE PEDAL SUPPORT ASSEMBLY | 47110 | - | - | - |
| 7 | BRAKE PEDAL PAD | 47121 | - | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal support assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
47210L 1.REMOVE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
2.REMOVE AIR DUCT SUB-ASSEMBLY
89510D 3.REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY
84345 4.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
82111 5.DISCONNECT ENGINE ROOM MAIN WIRE
47110 6.DISCONNECT BRAKE PEDAL SUPPORT ASSEMBLY
47121 7.REMOVE BRAKE PEDAL PAD