| *1 | TRANSMISSION WIRE CLAMP | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transmission wire removal/installation are shown below.
35400A 1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY
89413V 2.REMOVE TRANSMISSION REVOLUTION SENSOR (SP2)
89413N 3.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)
82125J 4.REMOVE TRANSMISSION WIRE
|
Turn |
|
Pull Down the Lever |
Remove the 3 bolts and 3 transmission wire clamps.
Using a 10 mm union nut wrench, remove the bolt as shown in the illustration.
Disconnect the transmission wire connector.
Disengage the claw, pull down the lever, and then disconnect the transmission wire connector.
Pull out the transmission wire from the automatic transmission assembly.
Remove the O-ring from the transmission wire.