| *1 | REAR OIL PUMP COVER SUB-ASSEMBLY | - | - |
35783 1.REMOVE DRIVEN SPROCKET
Using a screwdriver, remove the driven sprocket and E-ring from the front oi pump cover sub-assembly.
Be careful not to damage the front oil pump cover sub-assembly.
Tape the screwdriver tip before use.
35308 3.REMOVE FRONT OIL PUMP COVER SUB-ASSEMBLY
33405B 4.REMOVE OIL PUMP DRIVE SHAFT SUB-ASSEMBLY
35322 5.REMOVE FRONT OIL PUMP DRIVEN GEAR
35321 6.REMOVE FRONT OIL PUMP DRIVE GEAR
35311 7.REMOVE FRONT OIL PUMP BODY
35311A 9.REMOVE RING PIN
It is not necessary to remove the ring pins unless they are being replaced.