| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT WHEEL | - | - | - | - |
| 2 | FRONT FENDER APRON TRIM PACKING D | 53785B | - | - | - |
| 3 | CRANKSHAFT POSITION SENSOR | 11401G | ( ) |
- | - |
| ● | Non-reusable part | - | - |
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.REMOVE FRONT WHEEL
53785B 2.REMOVE FRONT FENDER APRON TRIM PACKING D
11401G 3.REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the crankshaft position sensor connector.
Remove the bolt and crankshaft position sensor.
If the crankshaft position sensor has been struck or dropped, replace it.
Perform this procedure only when reusing the crankshaft position sensor.
1. Remove the O-ring from the crankshaft position sensor.
Make sure to only remove the O-ring with bare hands.
When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
If the O-ring groove of the crankshaft position sensor is damaged, replace the crankshaft position sensor with a new one.