| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY RH | 23807M | - | - | - |
| 2 | NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY LH | 23808B | - | - | - |
| 3 | KNOCK CONTROL SENSOR | 89615 | ( ) |
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
23807M 1.REMOVE NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY RH
23808B 2.REMOVE NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY LH
89615 3.REMOVE KNOCK CONTROL SENSOR
|
|